
Sylvania ultra lightdisk led downlight kit install#
The SYLVANIA ULTRA LED Recessed and Surface Mount Downlight Kit (Light Disk) is designed to install in standard 4”, 5’’ and 6’’ insulated, non-insulated and air tight recessed downlight housings as well as fit inside existing standard 4” J-Box. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device complies with Part 15 of the FCC rules and has been tested and found to comply with the limits for a Class B digital device. To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other.Do not make or alter any open holes in an enclosure of wiring or electrical components during.Install this kit only in luminaires that have the constructionįeatures and dimensions shown in the photographs and/or drawings. This product contains a chemical known to the state of California to cause cancer, birth defects.Not for use whereĮxposed directly to the weather or water. This product is not intended for use in emergency light fixtures or exit signs.

To avoid electrical shock do not disassemble product.

Not all existing recessed housings that meet this requirement will be compatible with the Light Disk. Each lampholder shall be installed only in its intended manner and orientation. Note: It may be necessary to remove a socket mounting plate for adequate clearance in the compatible housing. Important safety information - read all instructions before installation.
